Ultra Sensitive DLATGS Detector FTS100KA

The DLATGS element is used for detection when extreme sensitivity is required that cannot be achieved using normal PZT sensors. The DLATGS has 5 to 8 times the sensitivity of PZT.  The FTS100KA uses a KRS-5 (Thallium Bromide) filter allowing a wide bandwidth of infrared energy to be detected. It is well suited for use in spectral analysis, radiation thermometer and similar equipment.

Model FTS100KA	Values	Unit	Condition
Element size	1.5 dia.	mm
Signal Sensitivity	typ. 22,000	V/W	500K, 1Hz
Noise	typ. 250	mV p-p	25°C, x5000
Source voltage	0.38 ~ 1.3	V	25°C
Supply voltage	2.0 ~ 10	V
Load resistor	10 ~ 1,000	kOhm
Operating temp.	-10 ~ 40	°C

Notes:	The sensor is better adapted where ambient temperature variation is small.
	Because of usage, a constant temperature environment is recommended.
	Operation at ambient temperatures above 40°C is not recommended.